Read the maker
Machine specs come from the manufacturer. Material settings come from their chart, their blog, or a named community library. A store's unsourced chart does not count.
Ocala, Florida · United States first · Worldwide readers
An xTool on slate, an OMTech cutting birch plywood, a Glowforge on anodized aluminum. Every number on this site is copied from a source, or it is marked as a starting estimate with the reason written out. Then you run a test grid on scrap from the same sheet.
Specs were read from the maker's own page. Where that page disagrees with itself, the machine page says so and does not pick a winner.
One machine and one material. The table shows the range and the source. A test on scrap comes before a finished piece.
Glowforge will not publish a custom anodized preset. Forum reports span 335 to full speed. None of them name the Pro, so each row is a starting estimate.
02 OMTech 60W settings for 1/8 inch birch plywoodOMTech prints 10–15 mm/s at 80–90% for 1/8 inch plywood on a 40–60W CO2, and a different 3 mm board row at 95%.
03 xTool F1 settings for engraving slateAn Atomm project prints an F1 diode start of 90–100% power, 150 mm/s, and 140 lines per cm. The project itself was made on a D1 Pro.
04 OMTech 60W settings for 3 mm cast acrylicOMTech's 60W chart says 15 mm/s optimal at 95% for 3 mm acrylic. Their blog says 10–15 mm/s at 65–75% for a 60–80W CO2.
05 OMTech 60W settings for vegetable-tanned leatherOMTech's 60W engrave row is 100 mm/s at 10–15%. Their 40–60W cut for 3–5 ounce veg-tan is 25–30 mm/s at 40–50%, one pass.
06 OMTech 60W settings for engraving glassOMTech's 40–60W CO2 glass row is 300 mm/s at 20% power, with a 0.1 mm line interval. It is an engrave, not a cut.
Power, speed, passes, interval, and focus, each tied to a source.
3 pagesLaser type, wattage, work area, and what the maker says it can and cannot do.
6 pagesWood, acrylic, leather, stone, metal, and glass, plus the materials you never put in the machine.
In the browserBuild a power and speed matrix for LightBurn or xTool Creative Space. Nothing you type is sent anywhere.
Machine specs come from the manufacturer. Material settings come from their chart, their blog, or a named community library. A store's unsourced chart does not count.
If the source prints 10 to 15 mm/s, the page prints 10 to 15 mm/s. It does not collapse that into one "best" speed.
If this site applies someone else's number to a different model, the row says "starting estimate" and shows the reason. Then you test it on scrap.